L Series C12L & C24L

L Series PCB

£18.00

Ex Tax: £15.00

Spare PCB for C12L and C24L controller units, cross compatible with IRR-PCB-LS

Availability: Out Of Stock
Product Code: IRR-PCB-L

Specifications

Contents 1 x PBC for L Series Controller

SOL-C12L and SOLC-24L Replacement PCB Boards

We have a stock of PCBs on hand in the unlikely event that an electrical fault develops, to assist keeping your device in good working order.

If we run out of stock, you can use the IRR-PCB-LS PCB board instead, because it is interchangeable with the IRR-PCB-L.

Once the supply of IRR-PCB-L is exhausted, IRR-PCB-LS will become the standard PCB board going forward.

Observe these guidelines to replace the board:

Turn the control unit over and remove the 5 screws from the rear lid

Open case lid and place to one side

Grab PCB and slide vertically up

Remove the following wires from the PCB: Pump, Water Sensor, Moisture Sensor (if you have one connected), Solar Panel and Battery Pack, dispose of the faulty PCB

Take the new PCB and attach the wires into the correct locations. See the image on this page for a key to wire locations.

Take the now connected PCB, and with the cut corner facing down and away from you, and with the LCD and switch on the left hand side, slowly lower down into the plastic guides for the PCB.

Make sure that all your wires are still connected

Replace Lid

Screw shut

L Series PCB

Specifications

SOL-C12L and SOLC-24L Replacement PCB Boards

Observe these guidelines to replace the board:

Write a review

Out of stock!